What is eBGP multihop use ?
>> eBGP multihop use establish 2 BGP peer not direct connected that mean TTL value is more than 1, we can use scenario I-BGP (same AS number) or E-BGP (different AS number) to use eBGP multihop.
How between BGP peer not direct connected can communicate use TCP 179 ?
>> we need IGP to carry TCP 179 between BGP peer.
Let's look at this example.
This scenario :
o R1 & R2 establish BGP peer with different AS number
o BGP peer use loopback interface
o use static route to communicate with BGP neighbor
o between R1 & R2 use 2 link serial interface so to communicate with BGP neighbor can load balancing use these link
R1#
interface Serial1/1
ip address 10.1.1.1 255.255.255.252
end
interface Serial1/2
ip address 10.1.2.1 255.255.255.252
end
interface Loopback0
ip address 1.1.1.1 255.255.255.255
end
ip route 2.2.2.2 255.255.255.255 10.1.1.2
ip route 2.2.2.2 255.255.255.255 10.1.2.2
router bgp 1
no synchronization
bgp log-neighbor-changes
neighbor 2.2.2.2 remote-as 2
neighbor 2.2.2.2 ebgp-multihop 3
neighbor 2.2.2.2 update-source Loopback0
no auto-summary
R2#
interface Serial1/1
ip address 10.1.1.2 255.255.255.252
end
interface Serial1/2
ip address 10.1.2.2 255.255.255.252
end
interface Loopback0
ip address 2.2.2.2 255.255.255.255
end
ip route 1.1.1.1 255.255.255.255 10.1.1.1
ip route 1.1.1.1 255.255.255.255 10.1.2.1
router bgp 2
no synchronization
bgp log-neighbor-changes
neighbor 1.1.1.1 remote-as 1
neighbor 1.1.1.1 ebgp-multihop 3
neighbor 1.1.1.1 update-source Loopback0
no auto-summary
R1#sh ip ro 2.2.2.2
Routing entry for 2.2.2.2/32
Known via "static", distance 1, metric 0
Routing Descriptor Blocks:
* 10.1.1.2
Route metric is 0, traffic share count is 1
10.1.2.2
Route metric is 0, traffic share count is 1
R1#sh ip bgp sum
BGP router identifier 1.1.1.1, local AS number 1
BGP table version is 1, main routing table version 1
Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd
2.2.2.2 4 2 7 7 1 0 0 00:03:37 0
No comments:
Post a Comment